KMC MEP-5372 Direct Coupled, Modulating Fail-Safe ControlSet Actuator
The
KMC MEP-5372 ControlSet Actuator is designed to control small dampers or
specific VEP series valves. The actuator mounts directly to a 1/2” or 3/8”
diameter shaft, eliminating the need for expensive and complicated linkages.
Mounting to a 3/8” diameter shaft requires the HFO-0011 shaft adaptor (ordered
separately). The actuator may be controlled via a 2 to 10 VDC control signal
from a thermostat, controller or building automation system. A minimum of 50
in-lb. of torque is provided over the maximum angular rotation of 95°. Actuators
are factory calibrated for 2 to 10 VDC input signal (4 to 20 mA with 500 ohm
resistor) and 95° clockwise rotation. A 1 to 5 VDC feedback voltage output,
proportional to the control signal, is provided. This feedback can be used for
remote indication of damper position. An 18 VDC auxiliary power supply output is
provided to power CTE-5100 series thermostats or other system control devices.
Minimum and maximum end stops are standard to limit rotation. A gear
disengagement feature allows positioning of the actuator without power. An
optional single, double or triple auxiliary switch can be field installed.
Accessories:
CME–1002
Single auxiliary switch
CME–1004
Double auxiliary switch
CME–1006
Triple auxiliary switch
HFO–0011
3/8" shaft adaptor
HMO–4518
Connector for 1/2" flexible metal conduit
HMO–4520
Compression connector for plenum cable
HMO–4526
Female connector for 1/2" conduit
