KMC MEP-5062, 5072 Direct Magnetic Coupled Modulating ControlSet Actuator
The
KMC MEP-5062/5072 ControlSet Actuators are designed to control small dampers or
specific VEP series valves. The MEP-5062 is an 18°/minute actuator and the
MEP-5072 is a 60°/minute actuator. The actuators mount directly to a 1/2” or
3/8” diameter shaft, eliminating the need for expensive and complicated linkage.
Mounting to a 3/8” diameter shaft requires the HFO-0011 shaft adaptor (ordered
separately). The actuator may be controlled via a 2 to 10 VDC control signal
from a thermostat, controller or building automation system. A minimum of 50
in-lb. of torque is provided over the maximum angular rotation of 95°. The units
are factory calibrated for 2 to 10 VDC input signal (4 to 20 mA with 500 ohm
resistor) and 95° clockwise rotation. Counterclockwise rotation is obtained
by simply toggling a switch. A 1 to 5 VDC feedback voltage, proportional to the
feedback signal, is provided. This feedback can be used for remote indication of
damper position. An 18 VDC auxiliary power supply output is also supplied to
power other control devices in the system. Minimum and maximum end stops are
standard to limit the rotation. A gear disengagement feature allows
positioning of the actuator without power. An optional single, double or triple
auxiliary switch can be field installed.
Accessories are available:
CME–1002
Single auxiliary switch
CME–1004
Double auxiliary switch
CME–1006
Triple auxiliary switch
HFO–0011
3/8" shaft adaptor
HMO–4518
Connector for 1/2" flexible metal conduit
HMO–4520
Compression connector for plenum cable
HMO–4526
Female connector for 1/2" conduit
Part No
Description
Unit Price
Data Sheet
Add to Cart
MEP-5062
OBSOLETE REPLACE WITH MEP-4002 0-10 VDC 18DEG/MIN 50IN-LB
